5-AXIS Centric Vice SOLIDGRIP 77 GR.52, H=65, B=46, B2=52, L=130, Hardened steel

5-axis SOLIDGrip clamping and centring element for bores, for positive clamping of workpieces. The toggle clamp with positive locking offers many advantages over clamping situations with force-locking or friction-locking. Due to the external pre-clamping of the raw workpieces, outside the clamping and centring element in bores, it is not necessary to generate large forces in the clamping device itself. In this way, all processes requiring high force are transferred from the clamping fixture to the engraving station, making force intensifiers or similar devices on the clamping and centring element in bores unnecessary. This means that the clamping and centring plates in bores of 5 SOLIDGrip shafts can be designed to be compact and virtually free of interference. The purely mechanical actuator is as simple as it is sufficient, since positive-locking closure means that only minimal clamping forces are required, with maximum clamping forces at the same time.

The design was determined by function in order to generate maximum benefit in practice. The focus is on accessibility, handling and flexibility.

The SOLIDGrip 5-axis clamping and centring elements in bores can be used for a wide range of clamping tasks with various accessory options, in addition to clamping raw parts.
Material:
Steel.
Version:
hardened part.
Note:
Note that replacement clamping jaws must always be replaced in pairs.
Always use a torque wrench to tighten the tensioners.
The maximum tightening torque of the respective tensioner must be observed.
Application:
- Suitable for SOLIDPoint 52.
- Clamping with embossed clamping technology or smooth surfaces.
- The jaws can be used on both sides.
Advantages:
- SOLIDGrip clamping jaws with threaded holes.
- Corrosion protection through post-oxidised surfaces.
- Jaw groove for better handling and automated gripping.
- Improved drainage of chips and water.
- Snap-in rim for direct fastening.
- Clear, easy-to-read scale.
- Wear-resistant spindle coating.
On request:
- On request, the smooth jaw surfaces can be supplied with a tungsten carbide coating. This increases the holding force.
- SOLIDGrip replacement spindles.
Scope of delivery:
- 1 clamping and centring element in bores of 5 SOLIDGrip axes with zero-point pin.
Accessories:
- SOLIDGrip 77 - Jaw width 46 mm, clamping jaws with retaining teeth K3025.
- SOLIDGrip 77 - Jaw width 77 mm, clamping jaws with retaining teeth / smooth clamping step K3026.