Adjustable hinge form A, Horizontal/vertical 76X60, Mounting perforations, Chrome-plated zinc die-cast

Material:
Hinge and adjusting bushes in zinc die-cast.
Stainless steel shafts.
Version:
Hinge and adjusting bushes chrome-plated or black.
Shaft surface untreated.
Note:
Hinges for inset doors.
The hinges can be installed on the right-hand and left-hand side.

The arrows mark the centre of the adjustment travel "L" to facilitate assembly.

Doors and covers can be positioned in steps simply by moving the adjusting bushes. In this way, manufacturing tolerances and door gaps can be compensated and readjusted horizontally and vertically.

The knurled surfaces on the underside of the adjusting bushes and in the slotted holes of the hinge prevent accidental displacement.
The adjusting bushes completely cover the slotted holes so that no dirt accumulates inside the adjustment range.

The load values stated for the hinges are non-binding reference values and do not take safety factors into account, and therefore exclude any liability. The data stated are for information purposes and do not guarantee properties in a legal sense.

The load values were determined under laboratory conditions. The correct application of the hinges is the sole responsibility of the user.

Factors such as the wide variety of materials to which the hinges are fastened, the types of fastening, the climatic conditions and wear can influence the values determined.
Accessories:
Countersunk head screws with hexagon socket DIN EN ISO 10642 (M6) K0708.