PAK0420.116
Base with moulded-in nut, vibration-damping D1=M16, D=50, H=40, Steel
Estimated delivery: On request
Material:
Steel version:
Pressure plate, hardened steel, ball element, high-speed steel.
Stainless steel version:
Pressure plate and ball element, stainless steel.
Insulating plate, PUR elastomer (Sylomer V12).
Version:
Steel version:
Ball element in case-hardened steel, burnished. Burnished base.
Stainless steel version:
Untreated surface.
Insulating plate, grey, bonded, non-slip.
Application range from -30 °C to +70 °C.
Order example:
K0420.110
Note:
The load capacity given in the table is a recommendation of the permanent static load limit for use with the damping element. This static load corresponds to a surface pressure of 0,4 N/mm², at which the material achieves its optimum damping properties. The recommendation takes into account that, under dynamic loads, an additional stress occurs which can reach a pressure of up to 0,6 N/mm². The insulating plate absorbs vibrations and prevents the base with moulded-in nut from slipping. Base with moulded-in nut (without vibration damping), see K0395.
Drawing note:
1) Insulation plate
Steel version:
Pressure plate, hardened steel, ball element, high-speed steel.
Stainless steel version:
Pressure plate and ball element, stainless steel.
Insulating plate, PUR elastomer (Sylomer V12).
Version:
Steel version:
Ball element in case-hardened steel, burnished. Burnished base.
Stainless steel version:
Untreated surface.
Insulating plate, grey, bonded, non-slip.
Application range from -30 °C to +70 °C.
Order example:
K0420.110
Note:
The load capacity given in the table is a recommendation of the permanent static load limit for use with the damping element. This static load corresponds to a surface pressure of 0,4 N/mm², at which the material achieves its optimum damping properties. The recommendation takes into account that, under dynamic loads, an additional stress occurs which can reach a pressure of up to 0,6 N/mm². The insulating plate absorbs vibrations and prevents the base with moulded-in nut from slipping. Base with moulded-in nut (without vibration damping), see K0395.
Drawing note:
1) Insulation plate
| Material | Steel |
|---|---|
| Thread | M16 |
| H3 (na compressão 0 / 0,4 / 0,6 N/mm²) | 8 / 6,8 / 5,9 |
|---|---|
| SW | 24 |
| D1 | M16 |
| D3 | 40,5 |
| H1 | 32 |
| T | 14 |
| H2 | 7 |
| Denominação | Base com porca injetada |
| Versão 1 | amortecedor de vibrações |
| D | 50 |
| H | 40 |
| Capacidade de carga máx. kN | 0,435 |
