Compact swing clamp, Style C single, DK=14, HUB=6, Perforated steel channels, Hydraulic

Compact swing clamps are designed for clamping fixtures in which the clamping points must be free when inserting or removing. In addition, they are suitable for restricted installation conditions. Compact swing clamps work as single- or double-acting pull cylinders. Three housing types are available, as well as different drive types for the compact swing clamps. The clamping movement is initiated by a rotary movement combined with a superimposed lifting movement. The actual clamping stroke takes place in a linear movement. A variety of options is available with a swivel angle to the left or right of 90°.
Material:
Housing and piston in steel.
NBR seal.
Version:
Burnished housing.
Hardened piston.
Note:
If the permissible volumetric flow rate is exceeded on the swing clamp, a throttle check valve must be installed in series.
The permissible operating pressure of the swing clamps depends on the length of the clamping arm.
When mounting the clamping arms, they must be held in place to avoid damaging the linear ball guides of the swing clamps.
Depending on the ventilation connection, the sintered filter of the single-acting swing clamps must be replaced with a threaded plug.

The clamping arm for the compact swing clamp is included in the scope of delivery.

Observe the safety instructions.
Operating mode:
- Threaded connection.
- O-ring flange connection.
- Drilled channels.
Mounting:
See construction outline.
Advantages:
- Compact design.
- Many variants.
- Collision-free access to the workpiece.
On request:
Larger piston diameters and strokes, other swivel angles, various supports for clamping arms with position monitoring.
Scope of delivery:
- 1 piece, slotted nut M27x1,5 (only on compact swivel clamps K1862.14081104190100, K1862.14081104190200, K1862.14062104190100, K1862.14062104190200).
- 1 piece, screw or nut for clamping arm support.
Accessories:
Clamping arm for compact swing clamp K1863.
Technical data:
Max. operating pressure: 350 bar.
Drawing note:
Form AGW: flange on top, threaded connection
Form AOF: flange on top, O-ring flange connection
Form BGW: flange at the bottom, threaded connection
Form BOF: flange at the bottom, O-ring flange connection
Form C: screw-in thread

1) Design contour
2) See accessories
3) On single-acting cylinders, the connection is fitted with a sintered filter
4) rotatable anticlockwise
5) rotatable clockwise
6) included in the scope of delivery