Floating clamp, Style A, Case-hardened steel nitrided, Burnished and ground, Components: aluminium red anodised, L5=10

Material:
Main body and jaw in case-hardened steel.
Aluminium housing.
Version:
Main body nitrided, burnished and ground.
Nitrided and burnished jaw.
Red anodised housing.
Order example:
K1228.100812
Note:
The floating support is used to clamp and support over-determined clamping points on components. It prevents vibrations and deflection during machining.
Operating mode:
1. Press the floating clamp down.
2. Turn the jaw until it reaches the stop. The clamping element rests against the underside of the workpiece with a low spring force.
3. Tighten the floating clamp with the hexagon nut (A/F 18), observing the min. and max. In the clamping procedure, the part is clamped and supported simultaneously.
4. To release the clamping, carry out the same steps in reverse order.
Mounting:
Form A:
Fasten the floating clamp to the fixture with the connection thread M12.
Adjust the height stop and the swivel range with the adjusting bush and secure with threaded pins (3x SW 2,5). When adjusting the upper height limit, allow a generous clearance.
For safe operation, the threaded hole M12 must always be closed.
For specific clamping situations, series-produced jaws can be modified or replaced.

Form B:
Fasten the floating clamp to the fixture with the fastening bore M6.
Adjust the lashing and lifting height of loads and the angle of rotation with the red adjusting bush and secure with threaded pins (4x SW 2,5). When adjusting the upper height limit, allow a generous clearance.
For specific clamping situations, series-produced jaws can be modified or replaced.