Indexing plunger ECO short version TA.3 D1=M16, D=8, Style D with latching groove with lock nut, Non-hardened steel

Indexing plungers are used when it is necessary to prevent a change in the locking position due to lateral forces. It can only be moved to another locking position after the pin has been disengaged manually. If the disengagement is carried out over a longer period of time and the guided locking pin must not return, form C or form D should be used.

Indexing plungers with standard metric thread and unpolished, unhardened locking guide pins are an economical alternative to the existing indexing plungers. However, this accuracy is sufficient for many applications. The lower manufacturing tolerances also make the products less sensitive to misalignment, which can occur when aligning the indexing plungers with the hole in the counterpart.
Material:
Steel version:
Threaded bush in free-cutting steel 1.4305.

Stainless steel version:
Threaded bush and locking guide pin 1.4305.

Thermoplastic mushroom head.

Version:
Steel version:
Blue passivated threaded bush.
Unhardened guide pin for locking, untreated surface.

Stainless steel version:
Threaded bush, untreated surface.
Unhardened guide pin for locking, untreated surface.

Mushroom-head knob in dark grey RAL 7021.
Note:
During assembly, the max. tightening torque must be observed. specified.
On request:
Special versions.