Indexing plunger with locking guide pin, With latching groove with lock nut D1=M10X1, D=5, Form A without

Indexing plungers are used to prevent changes in the engagement position caused by transverse forces.

If the locking marking is visible, the pin is fully unlocked or only partially engaged.
Material:
Housing and pin in steel.
Locking marking and adhesive label in aluminium.
PA (polyamide) thermoplastic rotary knob.
Version:
Nickel-plated housing and pin.
Locking marking anodised, red.
Glass-fibre-reinforced rotary knob, black.
Operating mode:
Form A:
Make sure that the rotary knob is in the "OFF" position and that the pin
is in the retracted state.
Slide the plate with the bush under the indexing plunger.
Turn the rotary knob to the "ON" position to lock.
When it reaches the locking point, the device emits an audible click.
Caution: do not release the indexing plunger when it is under axial load.
Due to the conical shape, it is possible that the pin does not retract.


Form B:
When the rotary knob is in the "OFF" position, move the plate with the bush
in the direction of the indexing plunger until the pin engages in the bush, due to the pressure
of the spring.
The rotary knob moves automatically to the "MID" position.
For complete locking, turn the knob from position "MID" to "ON", until a
click.
Scope of delivery:
The lock nut and the adhesive label with a thickness of 0,2 mm are included in the delivery.
Accessories:
Bush K1835.
Drawing note:
1) Mounting without bush K1835
2) Screw-on plate
3) Base plate
4) Locking mark
5) ON position
6) OFF position
7) Adhesive label