Latch smooth version, D=4, D1=10, Style F with bush, Smooth and cap, Untreated stainless steel, Components: graphite polypropylene

Latches are used to prevent changes in the engagement position, caused by transverse forces. When the latch is turned by 180°, the locking guide pin retracts, thus allowing the engagement position to be changed. The detent notch causes the latch to be held in this position, so that the locking guide pin remains retracted.
Material:
Latch 1.4308.
Bush 1.4301.
Locking guide pin 1.4305.
Compression spring 1.4310.
Latch cap in thermoplastic PA.
Version:
Bush and latch, untreated surface.
Ground guide pin for locking, untreated surface.
Compression spring with untreated surface.
Latch cap in different colours:
- dark grey RAL 7021
- pure orange RAL 2004
- rape yellow RAL 1021
- traffic red RAL 3020
- safety green RAL 6032
- traffic blue RAL 5017
- light grey RAL 7035
Note:
If the latches are welded, the bush must be tack-welded so that the spring is not thermally damaged by the high temperatures.
Advantages:
When the latch is turned by 180°, the locking guide pin retracts.
Optionally with coloured plastic latch caps.
Plain bush, connection option above push-in sleeve.
On request:
Special versions.
Accessories:
Locating bushes K1290, K1839, K1840.