Latch with hexagon, D=12, M20, Style AP without cap without lock nut, Untreated stainless steel

Latches are used to prevent changes in the engagement position, caused by transverse forces. When the latch is turned by 180°, the locking guide pin retracts, thus allowing the engagement position to be changed. The detent notch causes the latch to be held in this position, so that the locking guide pin remains retracted.
Material:
Latch 1.4308.
Threaded bush and locking guide pin 1.4305.
Compression spring 1.4310.
Latch cap in thermoplastic PA.
Thread-locking element in blue polyamide.
Version:
Threaded bush, pressure spring and latch, untreated surface.
Locking guide pin, ground and with untreated surface.
Latch cap in different colours:
- dark grey RAL 7021.
- pure orange RAL 2004.
- rape yellow RAL 1021.
- traffic red RAL 3020.
- safety green RAL 6032.
- traffic blue RAL 5017.
- light grey RAL 7035.
Advantages:
When the latch is turned 180°, the locking guide pin retracts.
Available with coloured plastic latch caps.
Bush with hexagon serving as assembly support.
On request:
Special versions.
Accessories:
Retaining part K0638.
Locating bushes K1290.
Drawing note:
Form AP: without locking cap, without nut.