Latch with stop, Left-hand, D=6, M16, Style D with threaded bush/nut/cap, Burnished steel, Components: graphite polypropylene

Latches are used to prevent changes in the engagement position, caused by transverse forces. When the latch is turned by 180°, the locking guide pin retracts, thus allowing the engagement position to be changed. The detent notch causes the latch to be held in this position, so that the locking guide pin remains retracted.
A stop of 180°–as steel latches prevents the engagement notch from coming loose and the locking guide pin from protruding again.
The choice of stop side (left, right) determines the direction of rotation of the latches.
Material:
Latch 1.0503.
Threaded bush and guide pin in free-cutting steel.
Compression spring 1.4310.
Latch cap in thermoplastic PA.
Version:
Burnished threaded bush and latch.
Guide pin for locking, hardened, polished and burnished.
Compression spring with untreated surface.
Latch cap in different colours:
- dark grey RAL 7021
- pure orange RAL 2004
- rape yellow RAL 1021
- traffic red RAL 3020
- safety green RAL 6032
- traffic blue RAL 5017
- light grey RAL 7035
Advantages:
When the latch is turned by 180°, the locking guide pin retracts.
Optionally with coloured plastic latch caps.
180° –Stop with unilateral direction of rotation.
On request:
Special versions.
Accessories:
Retaining part K0638.
Locating bushes K1290, K1839, K1840.
Drawing note:
1) Left-hand stop
2) Right-hand stop