Miniature indexing plunger TA.2 M12X1, 5, D=6, S=6, Style C with latching groove without lock nut, Untreated stainless steel

Indexing plungers are used when it is necessary to prevent a change in the locking position due to lateral forces. It is only possible to move to another locking position after the pin has been disengaged manually.
If the disengagement is carried out over a longer period of time and the guided locking pin must not return, form C should be used.

Mini indexing plungers can be used in many ways, especially in small installation spaces. They are an economical and space-saving alternative to the known standard designs.
Material:
Steel version:
Threaded bush in free-cutting steel 1.4305.

Stainless steel version:
Threaded bush and locking guide pin 1.4305.

Thermoplastic mushroom head.

Version:
Steel version:
Blue passivated threaded bush.
Guide pin for locking with untreated surface.

Stainless steel version:
Threaded bush and locking guide pin, untreated surface.

Mushroom-head knob in dark grey RAL 7021 or traffic red RAL 3020.
Note:
In form C, the mushroom-head knob can be turned 30° to hold the locking pin in the retracted position.
Mounting:
For mounting with an open-end spanner, the locking pin must be pulled out.
On request:
Special versions.
Accessories:
Spacer rings K0665.
Hexagon nuts K0700.
Locating bushes for indexing plungers K1290.
Drawing note:
Form A: without locking groove, without lock nut
Form C: with locking groove, without lock nut