Sliding clamp with slotted hole zinc die-cast, Orange, Components: thermoplastic T=6

Material:
Zinc die-cast housing.
PA (polyamide) thermoplastic rotary knob.
Stainless steel clamping pins and key.
POM spring plunger.
Version:
Chrome-plated housing.
Orange rotary knob, shot-peen reinforced.
Note:
The sliding clamps for slotted holes are inserted into an upper plate with a slotted hole 10 mm wide and then fixed to the lower plate. During assembly of the component, the rotary knob must be in the "OFF" position. Sliding clamps are used on precision plates with thicknesses of 3 mm or 6 mm. For other thicknesses, use shim plates K1071.
When the rotary knob is activated, the clamping pins mounted on the underside of the sliding clamp are tightened by springs and pressed downwards. Both clamping pins are pressed against the surface, locking the sliding clamp. Two spring plungers lift the sliding latch to the "ON" position and additionally serve to make it easier to move.
Accessories:
Shim plates K1071.
Operating principle:
Sliding clamps can be used in 2 different types of operation.

Operating mode 1:
Displaceable system.
If the sliding clamp is screwed on with a mounting element, it can move along a fixed plate with slotted hole.

Operating mode 2:
Fixed system.
If the sliding clamp is screwed (fixed) directly onto a plate, the plate with slotted hole can be displaced.
Drawing note:
1) Spring plungers (2x)
2) Chamfer ~0,3