Square latch, Weldable TA.1, D=6, Style H with cap, Untreated stainless steel, Components: orange thermoplastic

Latches are used to prevent changes in the engagement position, caused by
transverse forces.
When the latch is turned 180°, the locking guide pin retracts, thus allowing the
the latching position.
The detent notch causes the latch to be held in this position and the pin
remains retracted.
Material:
Latch 1.4308.
Bush 1.4301.
Locking guide pin 1.4305.
Compression spring 1.4310.
Latch cap in thermoplastic PA.
Version:
Bush and latch, untreated surface.
Ground guide pin for locking, untreated surface.
Compression spring with untreated surface.
Latch cap in different colours:
- dark grey RAL 7021
- pure orange RAL 2004
- rape yellow RAL 1021
- traffic red RAL 3020
- safety green RAL 6032
- traffic blue RAL 5017
- light grey RAL 7035
Note:
Thanks to the square bush, the latches are suitable for welding. Positioning by spot welding is recommended to avoid excessive heating of the spring.
Advantages:
When the latch is turned by 180°, the locking guide pin retracts.
Optionally with coloured plastic latch caps.
Square bush for welding.
On request:
Special versions.
Accessories:
Locating bushes K1290, K1839, K1840.