Square latch, Weldable TA.3, D=8, Style G without cap, Burnished steel

Latches are used to prevent changes in the engagement position, caused by
transverse forces.
When the latch is turned 180°, the locking guide pin retracts, thus allowing the
the latching position.
The detent notch causes the latch to be held in this position and the pin
remains retracted.
Material:
Latch and guided locking pin in steel.
Bush 1.0403.
Compression spring 1.4310.

Version:
Burnished bush and latch.
Guide pin for locking, hardened, polished and burnished.
Compression spring with untreated surface.
Note:
Thanks to the square bush, the latches are suitable for welding. Positioning by spot welding is recommended to avoid excessive heating of the spring.
Advantages:
When the latch is turned by 180°, the locking guide pin retracts.
Optionally with coloured plastic latch caps.
Square bush for welding.
On request:
Special versions.
Accessories:
Locating bushes K1290, K1839, K1840.