Threaded lifting pin, D1=M16, F1=8, 4, Manganese-phosphated steel

Material:
Hardened steel pin, hardened.
Shackle in hardened steel, hardened.
Threaded element in stainless steel 1.4542.
Aluminium push button.
Spring in stainless steel.
Version:
Pin with manganese phosphate coating.
Shackle with manganese phosphate coating.
Precipitation-hardened threaded element.

Orange anodised push button.
Order example:
K2154.10
Note:
Swivel eyes with a swivel shackle are used as a quick and easy transport/support element.
The threaded segments can be unlocked by pressing the push button, allowing the swivel eye bolt to be inserted into or removed from the threaded hole. When the push button is released, the threaded segments lock securely. The time-consuming process of screwing in and unscrewing, as is the case with an eye bolt, for example, is therefore no longer necessary.

The swivel shackle can be rotated by 180°. The safety pin on the shackle protects the push button against accidental release under linear tension.

For its use, a threaded hole with suitable dimensions and the corresponding strength is required.

Each swivel eye comes with detailed operating instructions.

Corrosion resistant.

With TÜV certification (German).

The specifications X min., F1, F2 and F3 are tested in accordance with DIN EN 13155 and the test load corresponds to 3 times the nominal load.
Temperature range:
max. +250 °C.
Mounting:
Mounting:
1. Press the button and hold it down.
2. Fit the swivel eye bolt.
3. Release the button (the button must
be in the initial position again).
4. Tighten the swivel eye by hand until
that it is fully in contact with the
seating surface.
5. Make sure that the segments
threaded are engaged in the thread
locating.

Disassembly:
1. Turn the swivel eye about a quarter
back counter-clockwise.
2. Press the button and hold it down.
3. Remove the swivel eye bolt.
4. Release the button.