Threaded lifting pin, With rotatable shackle, D1=M20, F1=16, 6, Stainless steel manganese phosphate

Material:
Stainless steel pin 1.4542.
Shackle in stainless steel 1.4571.
Threaded element in stainless steel 1.4542.
Aluminium push button.
Spring in stainless steel.
Version:
Precipitation-hardened pin.
Precipitation-hardened threaded element.
Orange anodised push button.
Order example:
K2157.10
Note:
Swivel eyes with a movable swivel shackle are used as a quick and easy transport/support element.
The threaded segments can be unlocked by pressing the push button. The swivel eye can then be inserted into or removed from the threaded hole. When the push button is released, the threaded segments lock securely. The time-consuming process of screwing in and unscrewing, as is the case with an eye bolt, for example, is therefore no longer necessary.

During lifting, the swivel shackle is always aligned in the direction of pull, without the pin rotating. The safety pin on the shackle protects the push button against accidental release under linear tension.

For its use, a threaded hole with suitable dimensions and the corresponding strength is required.

Each swivel eye comes with detailed operating instructions.

Corrosion and weather resistant.

With TÜV certification (German).

The specifications X min., F1, F2 and F3 are tested in accordance with DIN EN 13155 and the test load corresponds to 3 times the nominal load.
Temperature range:
max. +250 °C.
Thread size M24: from 150 °C, linear reduction of load capacity by 23%.
Mounting:
Mounting:
1. Press the button and hold it down.
2. Fit the swivel eye bolt.
3. Release the button (the button must
be in the initial position again).
4. Tighten the swivel eye by hand until
that it is fully in contact with the
seating surface.
5. Make sure that the segments
threaded are engaged in the thread
locating.

Disassembly:
1. Turn the swivel eye about a quarter
back counter-clockwise.
2. Press the button and hold it down.
3. Remove the swivel eye bolt.
4. Release the button.