Tongue latch knob, H=18, S=8, Black powder-coated zinc die-cast

Material:
Housing, actuator and nut in zinc die-cast.
NBR O-ring, CR flat sealing ring.
Version:
Chrome-plated housing, chrome-plated actuator or powder-coated in black.
Zinc-plated nuts.
Order example:
Latch key K2411.1181
Tongue K2244.145X040 (specify distance "A" of the tongue)
Note:
Can be used on the left or right with a closing angle of 90° and internal rotation limit. The tongue latch can be installed pre-assembled (with the small size “A” and thick doors, this is only possible with restrictions). The fixing nut is applied as an earthing nut with claws.

Protected against water and dust in accordance with IP65, thanks to the O-ring and the flat sealing ring.

These tongue latches with lock are each supplied with 2 keys. The key can be removed in both positions (open and close). The locks have identical keying, which means that each cylinder can be opened with the same key (lock 101 or 1333).

The tongues must be ordered separately in the desired design. Each tongue can be combined with any housing model.

*Dimension A results from the combination of tongue latch and tongue and is shown on the corresponding tongues.
Accessories:
Latch tongues for key lock without stop in steel K2244.