Unilock clamping station, Double version without anti-twist protection, B=199, L=399, H=60, Oxidised steel, Components: steel

Material:
Base plate, steel.
Clamping module in case-hardened steel.
Version:
Base plate, ground and oxidised on both sides.
Clamping module with hardened and polished functional surfaces.
Note:
Pre-assembled clamping stations with integrated UNILOCK ESM138-C clamping modules. The clamping stations are fastened to the machine table by means of clamping vices or by direct screw connection.
Clamping stations can be aligned using the reference bore 25H7 and the reference grooves 20H7.
The clamping modules are actuated centrally via a pneumatic connection.
The high clamping forces are generated by the integrated spring assembly (the unit is clamped without pressure).
The release process is pneumatic.

With UNILOCK guide pins in combination with the clamping screws M10, M12, M16, the following holding forces are possible:
- Holding force (M10) 35.000 N/module
- Holding force (M12) 50.000 N/module
- Holding force (M16) 75.000 N/module
Holding force with cylinder head screw DIN EN ISO 4762-12.9.

The guide pins can only be fastened in conjunction with an exchange unit in the clamping module.
Temperature range:
+5 °C to +60 °C.
On request:
Clamping station for special dimensions.
Scope of delivery:
- Clamping station.
- Push-in pneumatic connection.
- Operating instructions.
Accessories:
- UNILOCK clamping vices for UNILOCK clamping stations K1869.
- UNILOCK guide pin K0967.
- UNILOCK exchange pallets for zero-point clamping system K1218.
- UNILOCK protective pin for clamping modules K1010.
- UNILOCK cover for clamping modules K1010.
- Terminal strip for UNILOCK clamping stations K2352.
Technical data:
- Opening pressure: 6 bar, lubricated air.
- Air connection: G1/8.
- Repeat accuracy ≤0,005 mm.
- Reference bore 25H7 and reference slots 20H7 for aligning the clamping station.