Telescopic slide L=406 12, 7X51, 6, Over-extension S=432, Fp=80, Untreated stainless steel, Mounting

Material:
Rails in stainless steel 1.4301.
Ball cages in stainless steel 1.4301.
Balls in stainless steel 1.4034.

Version:
Rails with untreated surface.
Ball cages with untreated surface.
Balls with untreated surface.
Order example:
K1716.0356
Ordering note:
Sold in pairs.
Note:
In telescopic slides with over-extension, the stroke is greater than the mounting length. Latching in open position. The drawer can be easily removed and separated from the slides by actuating the release lever.
In an application with full extension stroke, the dynamic load capacity of the telescopic slides specifies the maximum load-bearing capacity of a telescopic pair mounted vertically. The specified load capacities were calculated with a rail spacing of 400 mm and refer to the maximum value at 10.000 cycles.

In horizontal mounting, the value decreases by 75%.

To avoid the risk of collision with other parts, the head height of the fastening screws must not exceed 2,5 mm.
Advantages:
Latching in open position
Quick removal of the front part
Drawing note:
1) Mounting hole not available on item K1716.0305