Telescopic slide L=660 9, 5X35, 3, Partial extension on both sides S=475, 5, Fp=27, Zinc-plated steel, Mounting

Material:
Steel rails.
Ball cages in steel.
Steel balls.
Version:
Zinc-plated rails.
Zinc-plated ball cages.
Hardened balls.
Order example:
K2379-0356
Ordering note:
Sold in pairs.
Note:
In telescopic slides with partial extension on both sides, the stroke is shorter than the mounting length. They represent an economical solution for drawers or similar mechanisms with low friction and high lateral stability. Latching in centre position. The lateral screw connections on the inner rail are replaced by structural support angle brackets. In an application with full extension stroke, the dynamic load capacity of the telescopic slides specifies the maximum load-bearing capacity of a telescopic pair mounted vertically. The specified load capacities were calculated with a rail spacing of 450 mm and refer to the maximum value at 50.000 cycles.

Not suitable for horizontal mounting.

To avoid the risk of collision with other parts, the head height of the fastening screws must not exceed 2,5 mm.
Advantages:
Extension in both directions
Smooth operation
High lateral stability due to precise guidance