Telescopic slide L=790 19, 1X53, Full extension S=803, Fp=80, Zinc-plated steel, Components: steel, Mounting

Material:
Steel rails.
Ball cages in steel.
Steel balls.
Version:
Zinc-plated rails.
Zinc-plated ball cages.
Hardened balls.
Ordering note:
Sold in pairs.
Note:
With telescopic slides with full extension, the stroke is approximately equal to the installation length, which ensures more comfort and accessibility. Latch in open and closed position. The telescopic slide can only be opened or closed by actuating the release lever. The dynamic load capacity of the telescopic slides indicates the maximum load supported by a pair of vertically mounted telescopic slides when the full extension stroke is used. The stated load capacities were determined with a rail spacing of 500 mm and refer to the maximum value after 80.000 cycles.

Not suitable for horizontal mounting.

The installation width between the body and the drawer must be 19,1 mm +0,2 mm to +0,5 mm for the rail thickness.

It is recommended to fasten the telescopic slide with a countersunk screw M5 or a 6 mm countersunk screw (Euro).

If required, the left and right levers can be connected by a horizontal bar.

Telescopic slides are supplied in pairs, but can also be used in combination with the telescopic slide K1718.

Telescopic slides must be loaded centrally. For wider drawers, the use of a central pull handle is recommended.
Temperature range:
-30 °C to +70 °C.